Blackmagic HyperDeck Disk Recorders Updating the Internal Software

The setup utility lets you update your HyperDeck disk recorder’s internal software in addition to configuring the streaming settings, network settings and streaming quality.

To update the internal software:

1. Download the newest Blackmagic HyperDeck Setup installer from www.blackmagicdesign.com/support.

2. Run the Blackmagic HyperDeck Setup installer on your computer and follow the onscreen instructions.

3. After installation is complete, connect your HyperDeck Studio to the computer via the USB or Ethernet connector on the rear panel.

4. Launch Blackmagic HyperDeck Setup and follow any onscreen prompt to update the internal software. If no prompt appears, the internal software is up to date and there is nothing further you need to do.

Download the latest setup utility for your Blackmagic HyperDeck Studio from the Blackmagic Design support center at