Blackmagic Cintel Scanner User Manual  Safety Information

For protection against electric shock, the equipment must be connected to a mains socket outlet with a protective earth connection. In case of doubt contact a qualified electrician.

To reduce the risk of electric shock, do not expose this equipment to dripping or splashing.

Product is suitable for use in tropical locations with an ambient temperature of up to 40C. Note, however, that ideal film conditions are between 18 and 28 degrees Celsius.

Ensure that adequate ventilation is provided around the product and that it is not restricted.

No operator serviceable parts inside product. Refer servicing to your local Blackmagic Design service center.

Use only at altitudes not more than 2000m above sea level.

WARNING

The Cintel Scanner weighs up to 70kg / 155 pounds when loaded with film. This is significantly heavier than a large screen television. If you are unsure of the structural capability of the wall or desk to support the total weight of the scanner and film loaded then you must obtain the advise of a qualified engineer to correctly analyze the mounting to ensure safety. Incorrect installation will result in the scanner falling which could cause serious injury or death.

Desk Mounting

When desk mounting the scanner, and especially when working underneath your scanner to install the desk mounting screws, ensure that your work surface is flat and stable. Mounting brackets and fixings must be of sufficient strength to securely support the scanner’s weight. If your work surface is incapable of supporting the scanner’s weight, or loses strength over time, your scanner may fall, possibly causing serious personal injury.

Wall Mounting

When wall mounting the scanner, ensure that the installation location is strong enough to support long term use. If its strength becomes insufficient over the course of long term use, the scanner may drop, possibly causing injury. Do not install in places which are unable to bear loads. Mounting brackets and fixings must be of sufficient strength to securely support the scanner’s weight. If the strength of the installation surface is insufficient, the scanner may fall down and personal injury may result.

Desk or wall mounting your scanner MUST be undertaken by more than one person. Do not attempt installation on your own.

Operation

User interaction is required to operate the scanner, and the film loading process is inherently hands on. It is important to be aware that moving parts can be hazardous. Be sure to keep fingers and other body parts clear of the scanner when film is scanning.

State of California statement

This product can expose you to chemicals such as trace amounts of polybrominated biphenyls within plastic parts, which is known to the state of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.

Warning for Authorized Service Personnel

Disconnect power from both power inlets before servicing!