Frigidaire FPEH3077RF Manual

Table of Contents

• Product Record and Registration
• Important Safety Instructions
• Before Setting Surface Controls
• Setting Surface Controls
• Before Setting Oven Controls
• Setting Oven Controls
  • Cleaning Various Parts of Your Oven
  • Cooktop Maintenance
    • Figure 38: Cooktop care
  • Cooktop Cleaning
    • Figure 39: Cooktop cleaning
  • Cooktop Maintenance (cont’d)
    • Figure 40: Cleaning products to avoid
  • Removing and Replacing the Oven Door
    • 1. Open oven door completely horizontal with floor (See Figure 41).
      • 2. Pull the door hinge locks on both left and right door hinges up from the oven frame completely towards the oven door (See Figure 42). A tool such as a small flat- blade screwdriver may be required to unlock the hinge (Figure 43).
      • 3. Grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 44).
      • 4. Keep pulling the bottom of the door toward you while rotating the top of the door toward the appliance to completely disengage the hinge levers(Figure 44).
    • 1. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 44).
      • 2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 44). The hook of the hinge arms must be fully seated onto the roller pins.
      • 3. Fully open the oven door, horizontal with floor See Figure 41).
      • 4. Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges to the locked position (See Figure 42).
      • 5. Close the oven door.
      • Figure 41: Door hinge location
      • Figure 42: Door hinge locks
      • Figure 43: Hinge in unlocked position
      • Figure 44: Holding door for removal
  • Caring for your glide racks
    • 1. Remove the rack from the oven and place the rack on a large flat surface covered with newspaper or scrap cloth. Fully extend the rack.
      • 2. Wipe away debris and crumbs from the glide track using a cloth or sponge.
      • 3. Shake graphite lubrication very well before applying. Place four drops of graphite lubrication along the tracks (see area circled on figure below). Repeat on both sides of the glide rack.
      • 4. Extend and return the glide rack several times along the tracks to distribute the lubrication.
      • 5. Turn glide rack over. Shake graphite lubrication very well before applying. Place four drops of graphite lubrication along the tracks. Repeat on both sides of the glide rack.
      • 6. Extend and return the glide rack several times along the tracks to distribute the lubrication.
      • 7. Apply a thin layer of cooking oil to the outer frame of the glide rack as shown below. Keeping the frame sides lightly lubricated allows the entire rack to slide easily when changing rack positions.
  • Replacing the oven interior light bulbs:
    • 1. Turn electrical power off at the main source or unplug the appliance.
      • 2. Remove interior oven light by turning the glass cover counter-clockwise.
      • 3. Replace bulb with a new halogen appliance bulb.
      • 4. Replace glass oven light shield by turning the glass cover clockwise until tight.
      • 5. Turn power back on again at the main source (or plug the appliance back in).
      • 6. Be sure to reset the time of day on the clock.
      • Figure 45: Oven light protected by glass shield
  • Care and Cleaning
• Before You Call
• Warranty