SmartThings SmartPower™ Outlet Quick Start Guide

Thursday, July 20, 2017
Download

Meet the How to Connect a How to Reset and Reconnect a CAUTION: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES WARNING: Each module outlet is rated to 12A only if SmartPower™ Outlet SmartPower™ Outlet SmartPower™ Outlet AND REGULATIONS. IF YOU ARE UNSURE ABOUT ANY OF the connecting cord is rated at 90C or greater. The total current limit of the device is 12A. Do not exceed THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN. this value. If a direct short is created on the output, As you set up the SmartThings™ mobile app, you will see Remove the SmartPower Outlet from the wall UNPLUG UNIT WHEN SERVICING CONNECTED APPLIANCES. SAVE The SmartPower Outlet lets you remotely control lights, instructions that walk you through how to connect 1 receptacle. THIS INSTRUCTION SHEET. IT CONTAINS IMPORTANT TECHNICAL DATA ALONG WITH TESTING AND TROUBLESHOOTING the Appliance Module will be damaged and will no longer function. If a load greater than 12 AMPs is attached to the individual devices. You can also connect at any time by output, the Appliance Module will be damaged and will no electronics, and small appliances. Set your coffee maker INFORMATION WHICH WILL BE USEFUL AFTER INSTALLATION IS following these three steps: Press and hold the device’s Connect button while COMPLETE. longer function. to on in the morning or automate your lights to turn on Tap ‘+’ in the SmartThings mobile app to add 2 plugging the SmartPower Outlet back into the MISE EN GARDE! DOIT ÊTRE INSTALLÉ ET UTILISÉ AVERTISSEMENT! Chaque sortie du module est conçue pour 1 une tension de 12 A à condition d'être branchée à un câble wall. CONFORMÉMENT AU RÉGLEMENTATIONS ET AU CODES when the sun sets. You can also restrict the power used things. conçu pour des températures de 90 °C et plus. Cet appareil est ÉLECTRIQUES APPROPRIÉS. SI VOUS AVEZ DES DOUTES PAR conçu pour une tension maximale de 12 A. Ne dépassez pas Once the LED is ON, release the button and RAPPORT À CERTAINES INSTRUCTIONS, CONSULTEZ UN by fans, lights, and other plug-in appliances. Follow the on-screen prompts to connect your 3 follow the How to Connect steps. ÉLECTRICIEN QUALIFIÉ. DÉBRANCHEZ L'APPAREIL LORS DE cette limite. Si un court-circuit direct se produit à la sortie, le 2 device and set up top alerts and/or actions. L'ENTRETIEN DES APPAREILS QUI LUI SONT RATTACHÉS. CONSERVEZ CETTE FICHE D'INSTRUCTIONS. ELLE CONTIENT DES module d'appareil sera endommagé et ne fonctionnera plus. Si la sortie est rattachée à une charge supérieure à 12 A, le module. DONNÉES TECHNIQUES IMPORTANTES AINSI QUE DES When the app is looking for your SmartPower INSTRUCTIONS POUR LES TESTS ET LE DÉPANNAGE QUI SERONT 3 Outlet, simply plug it into a wall receptacle for it LED Light UTILES UNE FOIS L'INSTALLATION TERMINÉE. to be discovered. Installation Tips: The SmartPower Outlet works best if Connect Button it’s within 15 feet (4.5 meters) of the SmartThings Hub when you connect it.

Warning! Certifications This equipment generates, uses and can radiate radio frequency Product or part becomes SmartThings’ property. OF SUBSTITUTE PRODUCTS, OR ANY INCIDENTAL OR energy and, if not installed and used in accordance with the CONSEQUENTIAL DAMAGES, OR (II) ANY AMOUNTS IN EXCESS • Each module outlet is rated to 12A only if the connecting cord is SmartPower™ Outlet Contains FCC ID: W7Z-ZICM357SP. instructions, may cause harmful interference to radio Obtaining Service: To obtain warranty service, visit support.smartthings.com to speak with a service agent or open a OF THE PURCHASE PRICE FOR THE PRODUCT, IN EACH CASE rated at 90C or greater. communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does service request. Please be prepared to describe the Product that WHETHER RESULTING FROM THE USE OF OR INABILITY TO USE Tested to Comply With FCC Standards THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS • The total current limit of the device is 12A. Do not exceed this FOR HOME OR OFFICE USE cause harmful interference to radio or television reception, which needs service and the nature of the problem. A purchase receipt is value. can be determined by turning the equipment off and on, the user is required. The Product must be insured, and shipped freight WARRANTY, EVEN IF COMPANY HAS BEEN ADVISED OF THE encouraged to try to correct the interference by one or more of the POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT following measures: prepaid and securely packaged. You must contact support for a • If a direct short is created on the output, the Appliance Module will ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR Return Material Authorization Number (“RMA Number”) before be damaged and will no longer function. • Reorient or relocate the receiving antenna. CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION AND shipping any Product, and include the RMA Number, a copy of your FCC Statement • Increase the separation between the equipment EXCLUSIONS MAY NOT APPLY TO YOU. • If a load greater than 12 AMPs is attached to the output, the and the receiver. purchase receipt and a description of the problem you are Appliance Module will be damaged and will no longer function. Operation of this device is subject to the following two conditions: experiencing with the Product. Any claim under this Limited TO THE EXTENT PERMITTED BY APPLICABLE LAW, (1) this device may not cause interference, and (2) this device must • Connect the equipment into an outlet different from that to which the receiver is connected. Warranty must be submitted to SmartThings before the end of the SMARTTHINGS DISCLAIMS ANY AND ALL STATUTORY OR accept any interference, including interference that may cause Warranty Period. IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, Avertissement! undesired operation of the device. • Consult the dealer or an experienced radio/TV technician for help. Exclusions: This warranty does not apply to: a) damage caused by WARRANTIES OF MERCHANTABILITY, FITNESS FOR A • Chaque sortie du module est conçue pour une tension de 12 A à failure to follow instructions relating to the Product’s use or the PARTICULAR PURPOSE AND WARRANTIES AGAINST HIDDEN Information to the User One (1) Year Limited Warranty OR LATENT DEFECTS. IF SMARTTHINGS CANNOT LAWFULLY condition d'être branchée à un câble conçu pour des installation of components; b) damage caused by accident, abuse, températures de 90 °C et plus. Changes or modifications not expressly approved by Physical Physical Graph Corporation (“SmartThings”) warrants this product DISCLAIM STATUTORY OR IMPLIED WARRANTIES, THEN TO THE misuse, transport, neglect, fire, floods, earthquake or other external Graph Corporation could void your authority to operate the (the “Product”) against defects in materials and/or workmanship EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES SHALL equipment. causes; c) damage caused by service performed by anyone who is • Cet appareil est conçu pour une tension maximale de 12 A. Ne under normal use for a period of ONE (1) YEAR from the date of BE LIMITED IN DURATION TO THE WARRANTY PERIOD. SOME not an authorized representative of SmartThings; d) accessories dépassez pas cette limite. This device complies with Part 15 of the FCC rules. Operation is purchase by the original purchaser (“Warranty Period”). If a defect STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN used in conjunction with a covered Product; e) a Product or part subject to the following two conditions: arises and a valid claim is received within the Warranty Period, then IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS MAY • Si un court-circuit direct se produit à la sortie, le module that has been modified to alter functionality or capability; f) items 1 This device may not cause harmful interference and as your sole remedy (and SmartThings’ sole liability), SmartThings NOT APPLY TO YOU. d'appareil sera endommagé et intended to be periodically replaced by the purchaser during the 2 This device must accept any interference received, including will at its option either 1) repair the defect at no charge, using new normal life of the Product, including, without limitation, batteries, This warranty gives you specific legal rights and you may also have interference that may cause undesired operation. or refurbished replacement parts, or 2) replace the Product with a bulbs or cables; g) a Product that is used commercially or for a other rights, which vary from state to state. To exercise your rights This equipment has been tested and found to comply with the new product that is functionally equivalent to the original, in each commercial purpose, in each case as determined under this warranty, please follow the instructions above under the limits for a Class B digital device, pursuant to Part 15 of the FCC case within 30 days following receipt of the returned Product. A Rules. These limits are designed to provide reasonable protection by SmartThings. heading “Obtaining Service”, or contact SmartThings at Physical replacement product or part, assumes the remaining warranty of against harmful interference. EXCEPT FOR BODILY INJURY, SMARTTHINGS SHALL NOT BE Graph Corporation, 1000 Potomac St NW #120, Washington, DC the original Product. When a Product or part is exchanged, any LIABLE FOR (I) ANY LOST PROFITS, COST OF PROCUREMENT 20007. replacement item becomes your property and the replaced